How to Use

How to use Sea it!

Outboards: Pour 20ml into an outboard motor engine flush mixer and run outboard until warm and solution turns clear in the mixer. Run for an extra 5 minutes after solution turns clear in the mixer.

Cleaning: To clean all surfaces and to remove salt residues use at a rate of 30 to 1 (30 mls per litre) on all common surfaces which include fibre glass, glass, painted surfaces, alloy, steel, fabric and timber.

Glass Anti-fog: Make a solutions of 100 ml per litre in a spray bottle, spray and wipe off with a clean towel.

Protection: For wintering over protection or heavy duty cleaning use at a rate of 5 to 1 (200 mls per litre).

Tackle Maintenance: Make a solution of 100 ml per litre in a spray bottle, spray onto tackle, leave to penetrate then rinse off with fresh water. Application can be done by bucket and brush or sponge, or a pressure sprayer. To get the best results, hose all surfaces to remove any gross soils then apply the SEA-IT at the desired dilution and scrub any areas that are heavily soiled, then rinse off with clean water, this will leave and invisible protective layer on the surface.

SEA-IT is an environmentally responsible cleaner, salt remover and surface protectant for all areas of your boat, jet ski & trailer. SEA-IT is manufactured using readily biodegradable surfactants and chelating agents along with a protective polymer, to reduce the ability of salt, dirt and oil to re-adhere to surfaces that have been cleaned with SEA-IT.

How to set up the Sea-man Foamer

Step 1:
Screw in bottle to the orange top.

Step 2:
Push in Trigger to the brass end

Step 3:
Attach the foaming stick to the orange foamer

Step 4:

Connect garden hose attachment to the back of the trigger and your ready to clean!

How much Sea-it should I put in my foamer?
We recommend putting 25-40ml into your foamer bowl and topping that up with water to the top.

Setting:
We recommend using Setting “A” on the foamer when washing your boat, ski, ute or other.

Use Setting “0” to rinse the product off. 0 uses no product and only water.,

Tip: If you use Sea-IT and you get Streaks on your boat left over you are using too much.

FIRST AID AND SAFETY INSTRUCTIONS
Eyes: Avoid contact with eyes. If in eyes, hold eyes open and flush with water for at least 15 minutes. Skin: Rinse with water. Swallowed: Do not induce vomiting, give a glass of water. If poisoning occurs seek medical advice and show the label and SDS whenever possible.

More information is available on Safety Data Sheets.
Emergency Poisons Number
NZ: 0800-764-766 International: +643-479-7227
Made in New Zealand.